NS3000/iX Error Messages Reference Manual (36923-90043)

408 Chapter18
PCI LAPBMUX Link Error Messages
SDI Driver Specific Status Values
link software or contact your Hewlett-Packard Representative for
assistance.
1420 CLAS0001 MESSAGE: Cannot add driver to I/O system.
CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator attempted to create a new instance of the link
driver, but encountered an error which was not one of the legal errors
the configurator was able to handle (“Cause” = 32-bit status from the
call to io_configure).
ACTION: The module configurator cleaned up and returned an error to
the subsystem.
Verify the path in NMCONFIG is correct and complete, and matches
the path where a supported WAN ACC Sync MUX adapter card is
installed in your computer backplane. A diagram of the backplane slot
paths, often found in the rear of your system near the backplane, may
help you. You can also try an offline diagnostic utility such as MAPPER,
or an online utility such as SYSMAP, to precisely determine your
hardware configuration. If necessary, change NMCONFIG or contact
your Hewlett-Packard Representative for assistance in determining
paths or correcting bus hardware problems.
1440 CLAS0001 MESSAGE: Cannot load Driver plabel.
CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator encountered an error while trying to load the
code for the DM (Device Manager) (“Cause” = 32-bit status from the call
to io_get_mgr_entry).
ACTION: Probably not all software required to operate this type of link
is installed. The software was incorrectly installed, or you may need to
purchase additional software or install newer patches. Reinstall the
link software or contact your Hewlett-Packard Representative for
assistance.
1460 CLAS0001 MESSAGE: Cannot add driver to I/O system.
CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator attempted to create a new instance of the DM
(Device Manager) for link driver, but encountered an error which was
not one of the legal errors the configurator was able to handle
(“Cause” = 32-bit status from the call to io_configure).
ACTION: The module configurator cleaned up and returned an error to
the subsystem.
Verify the path in NMCONFIG is correct and complete, and matches
the path where a supported WAN ACC Sync MUX adapter card is
installed in your computer backplane. A diagram of the backplane slot
paths, often found in the rear of your system near the backplane, may
help you. You can also try an offline diagnostic utility such as MAPPER,
or an online utility such as SYSMAP, to precisely determine your