NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 18 417
PCI LAPBMUX Link Error Messages
SDI Driver Specific Status Values
different slot, may not be making proper contact with the PCI
backplane, or may not be responding. If the I/O slot has a power
indicator, verify it is on. Re-seat the board, and if necessary, contact
your HP Representative for hardware assistance.
2080 CLAS0001 MESSAGE: Unable to write to adapter card PCI configuration space.
CAUSE: During driver startup, during a restart following a reset
operation, or during processing of a utility register read request, the
driver called the I/O System to read data from an adapter register in
PCI Configuration Space, but the I/O System reported an error.
ACTION: The adapter card may have been removed, moved to a
different slot, may not be making proper contact with the PCI
backplane, or may not be responding. If the I/O slot has a power
indicator, verify it is on. Re-seat the board, and if necessary, contact
your HP Representative for hardware assistance.
2120 CLAS0001 MESSAGE: Unable to read from adapter card PCI configuration
space.
CAUSE: During driver startup, during a restart following a reset
operation, or during processing of a utility register read request, the
driver called the I/O System to read data from an adapter register in
PCI Configuration Space, but the I/O System reported an error.
ACTION: The adapter card may have been removed, moved to a
different slot, may not be making proper contact with the PCI
backplane, or may not be responding. If the I/O slot has a power
indicator, verify it is on. Re-seat the board, and if necessary, contact
your HP Representative for hardware assistance.
2160 CLAS0001 MESSAGE: Unable to write to adapter card PCI configuration space.
CAUSE: During driver startup, during a restart following a reset
operation, or during processing of a utility register read request, the
driver called the I/O System to read data from an adapter register in
PCI Configuration Space, but the I/O System reported an error.
ACTION: The adapter card may have been removed, moved to a
different slot, may not be making proper contact with the PCI
backplane, or may not be responding. If the I/O slot has a power
indicator, verify it is on. Re-seat the board, and if necessary, contact
your HP Representative for hardware assistance.
2200 CLAS0001 MESSAGE: Bad message for current state.
CAUSE: The driver received a new open from an upper layer subsystem,
at a time the driver was not able to process these requests, such as
during shutdown or after a fatal software error (“Cause” = 16-bit
encoded value, giving driver input event code and current state:
Hewlett-Packard use only).
ACTION: The open failed. Check the system console; if the driver is