NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 20 443
LAP-B Link Error Messages
LAP-B Link Driver Error Messages
LAP-B Link Driver Error Messages
This section describes error messages generated by the LAP-B Link
Driver. They are displayed on the HP e3000 operator’s console in the
following format:
LAPB (linkname) Message text
LAPB (linkname) Error ErrorNum, Status = Status,
Path: PhysPath
1000 MESSAGE: The download file is too small.
CAUSE: Possible causes for this problem are as follows:
1. The download file is corrupt.
2. There is an incorrect version of the download file.
ACTION: Possible actions for this problem are as follows:
1. Replace the download file from your latest system update tape.
2. Check the version of the download file with NMMAINT and call your
Hewlett-Packard representative if incorrect.
1001 MESSAGE: The download file is too large.
CAUSE: Possible causes for this problem are as follows:
1. The download file is too large.
2. There is an incorrect version of the download file.
ACTION: Possible actions for this problem are as follows:
1. Replace the download file from your latest system update tape.
2. Check the version of the download file with NMMAINT and call your
Hewlett-Packard representative if incorrect.
1002 MESSAGE: No STEPs data structures are available.
CAUSE: A catastrophic internal resource error was detected.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard representative.
1003 MESSAGE: An unknown interrupt type was received from
IO_Services.
CAUSE: Internal error.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard representative.