NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 20 449
LAP-B Link Error Messages
LAP-B Link Driver Error Messages
raw dump file along with the error information displayed on the
console, call your Hewlett-Packard representative, and submit an CR.
1036 MESSAGE: Download file is incorrect for this driver.
CAUSE: Hardware was successfully downloaded, but the downloaded
code turned out to be for a different driver. Someone may have
incorrectly renamed a download file to have the name of the file
expected by the driver, or your download file or installed driver may be
extremely old and not matched.
ACTION: Run NMMAINT.PUB.SYS to verify the version of the download
file and driver. If the file is incorrect, attempt to restore a copy from a
system backup tape. If this does not solve the problem, you may need to
update your system and download file; call your Hewlett-Packard
representative.
1037 MESSAGE: Download file is too old for this driver.
CAUSE: Hardware was successfully downloaded but the revision of the
download file cannot be used with the version of the corresponding
installed driver because their interfaces are incompatible.
ACTION: Check to see if operators forgot to restore the latest download
file during a recent system update. If not, try restoring the file from a
system backup tape. If this does not solve the problem, you may need to
update your system and download file; call your Hewlett-Packard
representative.
1038 MESSAGE: Unable to obtain a buffer manager buffer.
CAUSE: Possible causes for this problem are as follows:
1. Terminating user programs have not freed buffers and/or buffer
pools they were using.
2. Some other process had obtained buffers reserved for use by the
driver while the driver was trying to initialize itself.
ACTION: Possible actions for this problem are as follows:
1. Warmstart the system and correct the user programs.
2. Try restarting the driver. If repeated link-restarts fail, a system
dump will be required; call your Hewlett-Packard representative.
1039 MESSAGE: Unable to release a buffer manager buffer.
CAUSE: The driver attempted to free memory which the buffer manager
did not recognize as a valid buffer, due to a driver problem or memory
data corruption. Also, a problem somewhere may have caused the
driver to attempt to free a buffer which was not in use.
ACTION: A system dump will probably be required; call your
Hewlett-Packard representative.