NS3000/iX Error Messages Reference Manual (36923-90043)

456 Chapter20
LAP-B Link Error Messages
LAP-B Link Driver Error Messages
2018 MESSAGE: Cannot autodial because of cabling problems.
CAUSE: Either no cable is attached, a non-autodial cable is attached, or
a bad autodial cable is attached.
ACTION: Check to see if the cable is properly attached. If it is, try
another cable. If you still get this error, write down the error
information displayed on the console, submit an CR, and call you local
Hewlett-Packard representative.
2500 MESSAGE: There was a read from the PSI which completed with a
error.
CAUSE: Possible causes for this problem are as follows:
1. The link is down.
2. You have a faulty PSI.
3. Internal driver, firmware or system error.
ACTION: Possible actions for this problem are as follows:
1. Check the cabling and modem on the PSI.
2. Run Sherlock Diagnostics on the PSI.
3. Write down the console error message, file an CR and call your
Hewlett-Packard representative.
2501 MESSAGE: The driver does not have any more storage for commands
to the PSI.
CAUSE: Unexpected use of driver subqueues may create this problem.
ACTION: Write down the error information displayed on the console,
submit an CR and contact your Hewlett-Packard representative.
2502 MESSAGE: The PSI has completed a bad command.
CAUSE: Bad Asynchronous event quad completed by the PSI.
ACTION: Write down the error information displayed on the console,
submit an CR and contact your Hewlett-Packard representative.
2503 MESSAGE: The driver is unable to continue operation.
CAUSE: The driver received a command or is in a state where it cannot
continue operation.
ACTION: Write down the error information displayed on the console,
submit an CR and contact your Hewlett-Packard representative.
2504 MESSAGE: An unexpected command was received by the driver.
CAUSE: A completion by the PSI was received in an invalid state.
ACTION: Write down the error information displayed on the console,
submit an CR and contact your Hewlett-Packard representative.