NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 21 477
Logging Location Codes
ARP Logging Location Codes
ACTION: Verify that the NMCONFIG.PUB.SYS file exists. If the file exists,
see Appendix A , “Submitting a CR,” of this manual.
65 CLAS0002 MESSAGE: None
CAUSE: Failed to send ARP request out over the network.
ACTION: See Appendix A , “Submitting a CR,”of this manual.
66 CLAS0002 MESSAGE: None
CAUSE: Failed to send ARP request out over the network.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
67 CLAS0002 MESSAGE: None
CAUSE: An attempt to get a buffer failed due to an internal error in the
buffer manager.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
68 CLAS0002 MESSAGE: None
CAUSE: Unable to deallocate timers due to internal errors in the
network timers module.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
69 CLAS0002 MESSAGE: None
CAUSE: Unable to deallocate timers due to internal errors in the
network timers module.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
70 CLAS0002 MESSAGE: None
CAUSE: Unable to reset a timer due to an internal error in the network
timers module.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
71 CLAS0002 MESSAGE: None
CAUSE: Unable to deallocate timers due to internal errors in the
network timers module.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
72 CLAS0002 MESSAGE: None
CAUSE: Unable to abort a buffer pending request during ARP module
termination.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
73 CLAS0002 MESSAGE: None
CAUSE: A frame too small to be an ARP packet arrived with an ARP
etype.