NS3000/iX Error Messages Reference Manual (36923-90043)

516 Chapter21
Logging Location Codes
Control Process Logging Location Codes
ACTION: It is not possible to tell from the console logging what function
code NETCP received, however if disc logging was enabled, the entire
received message was logged, which may aid debugging. The flow of
normal NETCP operations has been interrupted, and a network hang
may be imminent, especially if new :NETCONTROL commands are issued.
It may be necessary to restart the system to clear this problem. See
Appendix A , “Submitting a CR,” of this manual.
640 CLAS0002 MESSAGE: INTERNAL ERROR; Data dictionary error
CAUSE: While attempting to send a reply message back to NETUI to
complete the blocked :NETCONTROL START command that initially
created NETCP, no entry named “NETUI” was found in the CM Port
Dictionary to identify which session port number issued the command
(PARM = 16-bit result code returned by the call to dict_find). Usually
this means the user session which issued the command has somehow
been aborted. The CM Port Dictionary is an operating system lookup
service used by, but not part of, Transport.
ACTION: If a system shutdown was being done, ignore this message.
The network startup or shutdown should run to completion, and other
network operations should continue to work normally. Otherwise, if it
still exists, the user session which issued the command (typically the
system console) may be hung. Since it also owns resources, it cannot be
aborted, and a system restart will be needed to recover. You may
attempt a network stop on another terminal, then restart the system
and restart the network. In some versions of Transport, if this error
occurs NETCP will accidentally send the reply to a random port
number, and the effects of this are indeterminate. If the same problem
happens again, see Appendix A , “Submitting a CR,” of this manual.
641 CLAS0002 MESSAGE: INTERNAL ERROR; Module Deconfig Failed
CAUSE: While shutting down Transport due to a system shutdown or a
:NETCONTROL STOP command, NETCP detected an error or warning
while attempting to stop the Net Timers module (PARM = 32-bit status
returned by the call to nettmr_module_deconfig). Always preceded by
other errors from Net Timers, indicating the cause of the original
failure.
ACTION: This error in itself was not fatal, and shutdown continued.
However, some system resources may be lost until after the next system
restart. One possible cause would be if a tool has already been used to
stop Net Timers, in which case NETCP cannot stop it; in this case
ignore the error. Inspect the previous error, and if necessary, or if this
problem occurs repeatedly, see Appendix A , “Submitting a CR,” of this
manual.
642 CLAS0002 MESSAGE: INTERNAL ERROR; Module Deconfig Failed
CAUSE: While stopping an NI due to a system shutdown or a
:NETCONTROL STOP command, NETCP detected an error trying to
delete the NI (PARM = 32-bit escape code returned by the call to