NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 21 535
Logging Location Codes
NS Configurator Logging Location Codes
message port for the module (PARM = 32-bit status returned by the call
to create_port).
ACTION: There may be a problem with the Ports subsystem of MPE, or
the system may be low on memory. If necessary, see Appendix A ,
“Submitting a CR,” of this manual.
5 CLAS0002 MESSAGE: INTERNAL ERROR; Internal resource error
CAUSE: When NETCP attempted to create a new protocol module for an
existing NI, after successfully creating a Port Data Area, an error
occurred while trying to create a message pool for the modules message
port (PARM = 32-bit status returned by the call to create_pool).
ACTION: There may be a problem with the Ports subsystem of MPE, or
the system may be low on memory. If necessary, see Appendix A ,
“Submitting a CR,” of this manual.
6 CLAS0002 MESSAGE: INTERNAL ERROR; Internal resource error
CAUSE: When NETCP attempted to create a new protocol module for an
existing NI, after successfully creating some data structure, an error
occurred while trying to add that structure's ID into the NS Registry
(PARM = 32-bit status returned by the call to reg_add_entity).
ACTION: The NS registry may be full. Try stopping and restarting
Transport. If the problem persists, see Appendix A , “Submitting a CR,”
of this manual.
7 CLAS0002 MESSAGE: INTERNAL ERROR; Internal resource error
CAUSE: When NETCP attempted to create a new NI or a new protocol
module for an existing NI, after successfully creating a message port for
the module, an error occurred while trying to send the first
initialization message to it (PARM = 32-bit status returned by the call
to send_msg).
ACTION: There may be a problem with the Ports subsystem of MPE. See
Appendix A , “Submitting a CR,” of this manual.
8 CLAS0002 MESSAGE: INTERNAL ERROR; Internal resource error
CAUSE: When NETCP attempted to create a new protocol module for an
existing NI, after successfully creating a message port for the module
and sending other messages to it, an error occurred while trying to send
a Protocol Start message (PARM = 32-bit status returned by the call to
send_msg).
ACTION: There may be a problem with the Ports subsystem of MPE or a
bug in the Module Configurator. See Appendix A , “Submitting a CR,” of
this manual.
9 CLAS0002 MESSAGE: INTERNAL ERROR; Internal resource error
CAUSE: When NETCP attempted to create a new protocol module for an
existing NI, after successfully creating a message port for the module