NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 21 539
Logging Location Codes
CX Logging Location Codes
CX Logging Location Codes
1 CLAS0003 MESSAGE: None
CAUSE: The NS keyword table was not allocated during system startup
prior to an NS command execution.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
2 CLAS0003 MESSAGE: None
CAUSE: The NS global data segment was not allocated during system
startup, or has been lost.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
3 CLAS0003 MESSAGE: None
CAUSE: Bad format in the ASCAT.NET.SYS catalog.
ACTION: Check that the message sets of the ASCAT.NET.SYS catalog are
correct. Run the MAKECAT utility to prepare the message catalog
properly.
4 CLAS0003 MESSAGE: None
CAUSE: The NS keyword table is not large enough to contain all
keywords from the ASCAT.NET.SYS catalog.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
6 CLAS0002 MESSAGE: None
CAUSE: The NS keyword table extra data segment could not be
allocated.because of insufficient memory or free DSTs.
ACTION: Contact your system manager to increase the number of
configured DSTs or obtain more memory.
7 CLAS0003 MESSAGE: None
CAUSE: The port used for communication between CI and the VT server
could not be added to the MPE port dictionary.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
8 CLAS0003 MESSAGE: None
CAUSE: The VT change request could not be sent to the DSDAD process
port.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
9 CLAS0003 MESSAGE: None
CAUSE: The start VT port message could not be sent to the VT server
process.