NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 21 575
Logging Location Codes
IP Logging Location Codes
191 CLAS0002 MESSAGE: None
CAUSE: An error was detected while attempting to start a timer for
inbound reassembly (PARM = get_timer result).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
192 CLAS0002 MESSAGE: None
CAUSE: An inbound buffer could not be freed while processing a partial
datagram (reassembly) (PARM = bmgr_free_buffer result).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
193 CLAS0002 MESSAGE: None
CAUSE: An inbound buffer that was being held for reassembly could not
be freed (PARM = bmgr_free_buffer result).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
194 CLAS0002 MESSAGE: None
CAUSE: An inbound buffer could not be freed while processing a partial
datagram (reassembly) (PARM = bmgr_free_buffer result).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
195 CLAS0002 MESSAGE: None
CAUSE: An entry could not be allocated for managing a delayed reply
from either probe or dial.
ACTION: This may occasionally happen. However, if it is happening
frequently, the number of probe/dial wait queue elements may have to
be increased. The disadvantage of doing this is that additional buffers
are held while path resolution is under way. If the problem persists, see
Appendix A , “Submitting a CR,” of this manual.
196 CLAS0003 MESSAGE: None
CAUSE: Path resolution failure reported from a delayed probe/dial
request (PARM = ns_path_resolve result).
ACTION: May indicate a misconfiguration of network or a failed link.
197 CLAS0002 MESSAGE: None
CAUSE: A failure was detected while attempting to send NI a message
during outbound store and forward processing (PARM = send_msg
result).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
198 CLAS0002 MESSAGE: None
CAUSE: An error was detected while attempting to retrieve buffer pool
information about a store and forward pool (PARM = bmgr_pool_info
result).