NS3000/iX Error Messages Reference Manual (36923-90043)

576 Chapter21
Logging Location Codes
IP Logging Location Codes
ACTION: See Appendix A , “Submitting a CR,” of this manual.
199 CLAS0002 MESSAGE: None
CAUSE: IP was unable to add itself to the registry during initialization
(PARM = reg_add_entity result).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
200 CLAS0004 MESSAGE: None
CAUSE: IP was unable to terminate immediately because it has
outstanding buffer or path resolution requests. When these complete IP
will terminate.
ACTION: Informative.
201 CLAS0004 MESSAGE: None
CAUSE: A datagram was received that should be forwarded. However,
the network portion of the destination address is a broadcast value.
These datagrams will be discarded.
ACTION: Remote node is sending an illegal datagram.
202 CLAS0003 MESSAGE: None
CAUSE: A datagram was received that required forwarding, but the
node that it was to be forwarded to was directly connected to the
sending node. The datagram will be forwarded and a redirect message
will also be sent to the source of the datagram.
ACTION: If this happens frequently the sending node should be
reconfigured so that it does not send datagrams to this node to forward
them to a node that it is directly connected to.
203 CLAS0002 MESSAGE: None
CAUSE: A failure was detected when IP sent a message to a peer IP
during store and forwarding processing.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
204 CLAS0002 MESSAGE: None
CAUSE: An error was detected while attempting to send a msg to IPU
(PARM = send_msg result code).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
205 CLAS0003 MESSAGE: None
CAUSE: IP received a broadcast packet not addressed to the local node.
ACTION: If this occurs frequently, analyze the network traffic for the
sender of the broadcast packets.