NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 21 581
Logging Location Codes
L2Resolve Logging Location Codes
15 Log Class 3 MESSAGE: None
CAUSE: A connection request has been rejected.
ACTION: Informative message. The network has been shut down, or a
connection request has been refused by the other end.
17 Log Class 2 MESSAGE: None
CAUSE: Invalid request from upper layers in current state.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
18 Log Class 2 MESSAGE: None
CAUSE: Invalid request from lower layers in current state.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
19 Log Class 3 MESSAGE: None
CAUSE: Reject of an incoming connection request because maximum
number of connections active.
ACTION: A maximum of 64 connections is allowed. Retry connection
after one has been closed.
21 Log Class 3 MESSAGE: None
CAUSE: Connect event message before L2Resolve is fully operational.
ACTION: Wait for L2Resolve to finish initialization and try the
connection again. If the problem persists, see Appendix A , “Submitting
a CR,” of this manual.
22 Log Class 2 MESSAGE: None
CAUSE: Incoming connect reply before L2Resolve is fully operational.
ACTION: Wait for L2Resolve to finish initialization and try the
connection again. If the problem persists, see Appendix A , “Submitting
a CR,” of this manual.
23 Log Class 2 MESSAGE: None
CAUSE: Incoming disconnect reply; maximum connections exceeded.
ACTION: A maximum of 64 connections is allowed. Wait until one
connection is closed and try again. If the problem persists, see Appendix
A , “Submitting a CR,” of this manual.
24 Log Class 2 MESSAGE: None
CAUSE: Incoming disconnect reply before L2Resolve is fully
operational.
ACTION: Wait for L2Resolve to finish initialization and try the
connection again. If the problem persists, see Appendix A , “Submitting
a CR,” of this manual.