NS3000/iX Error Messages Reference Manual (36923-90043)

582 Chapter21
Logging Location Codes
L2Resolve Logging Location Codes
25 Log Class 2 MESSAGE: None
CAUSE: Incoming disconnect before L2Resolve is fully operational.
ACTION: Wait for L2Resolve to finish initialization and try the
connection again. If the problem persists, see Appendix A , “Submitting
a CR,” of this manual.
26 Log Class 2 MESSAGE: None
CAUSE: Unknown event before L2Resolve is fully operational.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
27 Log Class 2 MESSAGE: None
CAUSE: Outbound connect request would exceed maximum number of
connections.
ACTION: A maximum of 64 connections is allowed. Wait until a
connection is closed and try again.
28 Log Class 2 MESSAGE: None
CAUSE: Connect reply received for an unknown connection.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
29 Log Class 2 MESSAGE: None
CAUSE: Disconnect reply message when maximum number of
connections exceeded.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
30 Log Class 2 MESSAGE: None
CAUSE: Disconnect reply received for an unknown connection.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
31 Log Class 2 MESSAGE: None
CAUSE: Disconnect request received for an unknown connection.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
32 Log Class 2 MESSAGE: None
CAUSE: Invalid connect/disconnect message.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
33 Log Class 3 MESSAGE: None
CAUSE: Outbound connection request during network shutdown.
ACTION: Informative message. The network must be started for
successful connection.