NS3000/iX Error Messages Reference Manual (36923-90043)

586 Chapter22
Logging Location Codes Continued
Mapping Table
Mapping Table
1 CLAS0004 MESSAGE: None
CAUSE: Mapping table was created (PARM = Pointer to mapping table
control block).
ACTION: None.
2 CLAS0004 MESSAGE:
CAUSE: Mapping table was deleted (PARM = Pointer to mapping table
control block).
ACTION: None.
3 CLAS0002 MESSAGE: None
CAUSE: Error trying to obtain an entry from the pool of free mapping
table entries (PARM = Status code from new_get_table_entry call). In
most cases, this will mean that there are no free entries remaining.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
4 CLAS0002 MESSAGE: None
CAUSE: Unable to locate the DIAL entity entry while trying to send a
dial request message.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
6 CLAS0002 MESSAGE: None
CAUSE: Unable to locate the X.25 entity while trying to send a connect
request to Phobos.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
7 CLAS0002 MESSAGE: None
CAUSE: Unable to locate the Layer 2 Resolve entity while trying to send
a connect request to L2Resolve.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
8 CLAS0003 MESSAGE: None
CAUSE: IEEE 802.3 or Ethernet address mapping to IP address has
changed. Could be due to hardware change or could indicate possible IP
address duplication on the network.
ACTION: Review configuration of new nodes on the network.
10 CLAS0002 MESSAGE: None
CAUSE: Send message to Probe failed trying to get station address
mapping for an IP address.