NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 22 595
Logging Location Codes Continued
Net Timers Logging Location Codes
ACTION: This should never been seen outside the factory; submit an
CR.
3160 CLAS0002 MESSAGE: Failed trap-call test
CAUSE: Reported by Hewlett-Packard internal tests only. This
indicates a net timer trap- routine reported a false error, leading to
release of the popped timer.
ACTION: This should never been seen outside the factory; submit an
CR.
3180 CLAS0002 MESSAGE: Failed free-timer test
CAUSE: Reported by Hewlett-Packard internal tests only. This
indicates freeing of a popping net timer yielded a status other than one
indicating the timer was currently popping.
ACTION: This should never been seen outside the factory; submit an
CR.
3200 CLAS0002 MESSAGE: Failed free-timer test
CAUSE: Reported by Hewlett-Packard internal tests only. This
indicates freeing of a popping net timer, already previously freed,
yielded a status other than one indicating the timer was not in use.
ACTION: This should never been seen outside the factory; submit an
CR.
3220 CLAS0002 MESSAGE: Failed reset timer test
CAUSE: Reported by Hewlett-Packard internal tests only. This
indicates resetting of a popping net timer, previously freed, yielded a
status other than one indicating the timer was not in use.
ACTION: This should never been seen outside the factory; submit an
CR.
3240 CLAS0002 MESSAGE: Cannot freeze memory
CAUSE: While attempting to freeze a caller- specified statistics buffer
into memory, the system routine Freeze reported an error. Freezing is
required, to avoid page faults while Net Timers data structures are
locked for the statistics report (PARM = status from Freeze).
ACTION: Net Timers will continue to run as normal, though no
statistics data was obtained. Whichever utility was trying to read Net
Timers information did not get it. Submit an CR.
3280 CLAS0003 MESSAGE: Data truncated
CAUSE: A caller-specified statistics buffer was too small to hold the
entire statistics block. Partial statistics- reads are not supported; to
read statistics only, the caller must specify the exact length of the Net
Timers statistics block.