NS3000/iX Error Messages Reference Manual (36923-90043)

606 Chapter22
Logging Location Codes Continued
NI Logging Location Codes
NI Logging Location Codes
1 CLAS0005 MESSAGE: None
CAUSE: Device was idle for configured Idle Timeout and timer was
enabled for this device. Device will be disconnected (PARM = device
ldev).
ACTION: None.
4 CLAS0002 MESSAGE: None
CAUSE: Protocol ID in Protocol Stop message was not found in NI’s PID
table (PARM = Protocol ID).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
5 CLAS0002 MESSAGE: None
CAUSE: PID table is too small for the number of protocols being started
for this NI (PARM = Protocol ID which could not be started).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
6 CLAS0002 MESSAGE: None
CAUSE: CP asked NI to stop a device which NI could not locate in its
device tables (PARM = device ID).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
7 CLAS0002 MESSAGE: None
CAUSE: Device table is too small for the number of devices being
started for this NI, or a device was started twice by CP (PARM = Device
ID).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
11 CLAS0002 MESSAGE: None
CAUSE: NI received data on a Protocol ID which has no match in PID
table (PARM = Protocol ID).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
13 CLAS0002 MESSAGE: None
CAUSE: Dial Protocol owns the device, but another protocol was sent
data from the remote node (PARM = Violating Protocol ID).
ACTION: If this happens frequently, carefully check the configurations
on both the local and remote systems. See Appendix A , “Submitting a
CR,” of this manual.