NS3000/iX Error Messages Reference Manual (36923-90043)

608 Chapter22
Logging Location Codes Continued
NI Logging Location Codes
25 CLAS0002 MESSAGE: None
CAUSE: The protocol attempted to send data when no devices were
active (PARM = Protocol ID).
ACTION: Error should be preceded by other errors or a DELLINK
message. If not, see Appendix A , “Submitting a CR,” of this manual.
28 CLAS0004 MESSAGE: None
CAUSE: Network Interface Started (PARM = NI port data address).
ACTION: None.
29 CLAS0004 MESSAGE: None
CAUSE: Network Interface Stopped (PARM = NI port data address).
ACTION: None.
30 CLAS0002 MESSAGE: None
CAUSE: Trouble starting the idle device timer of the NI (PARM = status
from get_timer).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
44 CLAS0002 MESSAGE: None
CAUSE: While trying to send a connect request to a driver, a send_msg
failed (PARM = status from send_msg).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
46 CLAS0002 MESSAGE: None
CAUSE: CP asked NI to disconnect a device which NI could not find in
its device table (PARM = connect ID).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
48 CLAS0002 MESSAGE: None
CAUSE: While trying to send a disconnect request to a driver, a
send_msg failed (PARM = status from send_msg).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
49 CLAS0002 MESSAGE: None
CAUSE: CP asked NI to connect a device which NI could not find in its
device table (PARM = link ID).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
51 CLAS0002 MESSAGE: None
CAUSE: After receiving a connect confirmation event from a driver, NI
could not find the protocol for that device type, either X.25 or SNA, in
its PID table.