NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 22 619
Logging Location Codes Continued
Probe Logging Location Codes
48 CLAS0002 MESSAGE: None
CAUSE: Attempt to add PROBE to the mapping table during INIT
message failed (PARM = mapping error code).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
49 CLAS0002 MESSAGE: None
CAUSE: Could not delete the PROBE entity fromthe mappingtable in a
terminate sequence (PARM = mapping error code).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
52 CLAS0002 MESSAGE: None
CAUSE: Invalid device information in Probe’s data area.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
53 CLAS0002 MESSAGE: None
CAUSE: Invalid device information in Probe’s data area.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
55 CLAS0002 MESSAGE: None
CAUSE: Attempt to add MAP address failed.
ACTION: Increase the maximum number of nodes in the LAN 802.3 NI
screen in NMMGR. If error recurs, then see Appendix A , “Submitting a
CR,” of this manual.