NS3000/iX Error Messages Reference Manual (36923-90043)

62 Chapter5
NetIPC (SOCKERRS) Error Messages
ACTION: Verify that the proper bits are specified in the flags parameter.
Bit numbering is from left to right (0–31).
8 MESSAGE: INVALID OPTION IN THE opt RECORD.
CAUSE: An unsupported option was specified in the opt record, or a
nonprivileged user attempted to specify a privileged option.
ACTION: Check the options added to the opt record and remove or
modify the option. Verify that the opt record was initialized correctly
using INITOPT.
9 MESSAGE: PROTOCOL IS NOT ACTIVE.
CAUSE: A NETCONTROL has not been issued to activate the requested
protocol module.
ACTION: Notify your operator.
10 MESSAGE: PROTOCOL DOES NOT SUPPORT THE SPECIFIED
SOCKET TYPE.
CAUSE: The type of socket you are trying to create is not supported by
the protocol to be used.
ACTION: Use a different socket type or protocol.
12 MESSAGE: ERROR DETECTED WITH MAXIMUM MESSAGES
QUEUED OPTION.
CAUSE: Invalid option length specified or value of option is not positive.
ACTION: Correct option specification.
13 MESSAGE: UNABLE TO ALLOCATE AN ADDRESS.
CAUSE: No addresses were available for dynamic allocation.
ACTION: If unsuccessful the second time, see Appendix A , “Submitting
a CR,” of this manual.
14 MESSAGE: ADDRESS OPTION ERROR.
CAUSE: The address option in the opt record has an error in it (e.g.,
invalid length).
ACTION: Check the values being placed in the opt record.
15 MESSAGE: ATTEMPT TO EXCEED LIMIT OF SOCKETS PER
PROCESS.
CAUSE: User has already reached the limit of 64 sockets per process.
ACTION: Shut down any sockets which are not being used or have been
aborted.
16 MESSAGE: OUT OF PATH DESCRIPTORS OR PATH DESCRIPTOR
EXTENSIONS.
CAUSE: Transport’s Path Cache or Path Descriptor table is full.