NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 22 637
Logging Location Codes Continued
Remote Link Manager Logging Location Codes
19 CLAS0002 MESSAGE: None
CAUSE: RLM could not write outbound packet to buffer.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
20 CLAS0002 MESSAGE: None
CAUSE: RLM could not read buffer containing inbound packet.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
21 CLAS0001 MESSAGE: None
CAUSE: Mismatch in states between the DTC and the HP e3000.
ACTION: See Appendix A , “Submitting a CR,” of this manual. (Make
sure a dump is taken of both the DTC and the HP e3000.)
22 CLAS0002 MESSAGE: None
CAUSE: Mismatch in states between DTC and HP e3000.
ACTION: See Appendix A , “Submitting a CR,” of this manual. (Make
sure a dump is taken of both the DTC and the HP e3000.)
23 CLAS0001 MESSAGE: None
CAUSE: Mismatch in states between the DTC and the HP e3000.
ACTION: See Appendix A , “Submitting a CR,” of this manual. (Make
sure a dump is taken of both the DTC and the HP e3000.)
24 CLAS0001 MESSAGE: None
CAUSE: Mismatch in states between the DTC and the HP e3000.
ACTION: See Appendix A , “Submitting a CR,” of this manual. (Make
sure a dump is taken of both the DTC and the HP e3000.)
25 CLAS0003 MESSAGE: None
CAUSE: DTC returned bad status during link shutdown (PARM =
status returned by DTC).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
26 CLAS0002 MESSAGE: None
CAUSE: Subsystem (NS Transport) specified invalid link.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
27 CLAS0003 MESSAGE: None
CAUSE: Subsystem (NS Transport) attempted to connect X.25 card that
was in a bad state.
ACTION: Check status of X.25 protocol on DTC. Possible causes include
bad/disconnected cable between DTC and switch/X.25 network, or the
switch/X.25 network is down. When problem is corrected, HP e3000 will