NS3000/iX Error Messages Reference Manual (36923-90043)

638 Chapter22
Logging Location Codes Continued
Remote Link Manager Logging Location Codes
display additional logging messages.
28 CLAS0002 MESSAGE: None
CAUSE: Disconnect reply received from linkn contained bad status.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
29 CLAS0002 MESSAGE: None
CAUSE: Subsystem specified a bad parameter in a connect or
disconnect request.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
30 CLAS0001 MESSAGE: None
CAUSE: Control mismatch between DTC and HP e3000.
ACTION: See Appendix A , “Submitting a CR,” of this manual. (Make
sure a dump is taken of both the DTC and the HP e3000.)
31 CLAS0002 MESSAGE: None
CAUSE: DTC sent bad packet to HP e3000.
ACTION: See Appendix A , “Submitting a CR,” of this manual. (Make
sure a dump is taken of both the DTC and the HP e3000.)
32 CLAS0002 MESSAGE: None
CAUSE: Could not separate (“unbind”) with link.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
33 CLAS0002 MESSAGE: None
CAUSE: RLM attempted to send on a connection that was down.
ACTION: See Appendix A , “Submitting a CR,” of this manual. (Make
sure a dump is taken of both the DTC and the HP e3000.)
34 CLAS0003 MESSAGE: None
CAUSE: Close request received while resources were outstanding.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
35 CLAS0002 MESSAGE: None
CAUSE: Received packet from link on unknown connection.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
36 CLAS0002 MESSAGE: None
CAUSE: RLM could not free a buffer.
ACTION: See Appendix A , “Submitting a CR,” of this manual.