NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 22 641
Logging Location Codes Continued
Remote Link Manager Logging Location Codes
ACTION: See Appendix A , “Submitting a CR,” of this manual.
60 CLAS0002 MESSAGE: None
CAUSE: Invalid message received for current state.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
61 CLAS0003 MESSAGE: None
CAUSE: Link has gone down.
ACTION: Run appropriate diagnostics. If no error is found, see Appendix
A , “Submitting a CR,” of this manual.
62 CLAS0001 MESSAGE: None
CAUSE: Internal State Error.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
63 CLAS0002 MESSAGE: None
CAUSE: Link State Error.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
64 CLAS0002 MESSAGE: None
CAUSE: Subsystem (NS Transport) specified an invalid link.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
65 CLAS0005 MESSAGE: None
CAUSE: DTC link was closed successfully.
ACTION: None. (This is just an informative log.)
66 CLAS0005 MESSAGE: None
CAUSE: DTC link was closed while it was in a bad state.
ACTION: Check status of X.25 card on DTC.
67 CLAS0005 MESSAGE: None
CAUSE: DTC link was opened successfully.
ACTION: None.
68 CLAS0005 MESSAGE: None
CAUSE: HP e3000 link failure occurred while attempting to shut down
the DTC link.
ACTION: Check status of LAN hardware.
69 CLAS0005 MESSAGE: None
CAUSE: Contact with DTC was lost while attempting to shut down the
DTC link.