NS3000/iX Error Messages Reference Manual (36923-90043)

688 Chapter22
Logging Location Codes Continued
TCP Logging Locations
17002 CLAS0005 MESSAGE: None
CAUSE: We received an inbound syn for a connection that has already
been established (same local and destination SAPS and IP addresses).
We will ignore this SYN packet.
ACTION: Informative message. No action required.
17101 CLAS0005 MESSAGE: None
CAUSE: The user or service (through IPC) has rejected the passive
connection attempt, or an error has occurred on the connection since
the passive open request was received.
ACTION: Informative message. PARM is rejection reason. If PARM is 0,
user/service rejected the connection. Otherwise, an error condition has
been detected by TCP. Look for logging indication of other error on same
connection. (Remember that other logging classes may or may not be
enabled.) Network/nodal shutdown processing may cause this error. If
error is unexplainable, submit an CR.
17201 CLAS0005 MESSAGE: None
CAUSE: TCP connection deactivated due to an error.
ACTION: Informative message. No action required. Error type may be
normal or serious. Find matching error indication for connection and
follow action text. (Remember that all classes of logging may not be
enabled.)
17301 CLAS0003 MESSAGE: None
CAUSE: User or service attempted to create TCP socket which already
exists.
ACTION: Correct program/service in error or close previous socket
incarnation.
17401 CLAS0002 MESSAGE: None
CAUSE: TCP protocol start failed.
ACTION: Submit an CR.
17402 CLAS0002 MESSAGE: None
CAUSE: Bad status returned in message from TCP SIP during a
network startup. The TCP SIP wasn’t created.
ACTION: PARM indicates status from message. Look for logging
indication explaining TCP SIP initialization failure. Submit an CR.
17403 CLAS0002 MESSAGE: None
CAUSE: TCP SIP portid was not found.
ACTION: Suspect error in protocol startup or protocol initialization.
Look for logging indication explaining TCP SIP initialization failure.