NS3000/iX Error Messages Reference Manual (36923-90043)

698 Chapter22
Logging Location Codes Continued
X.25 Logging Location Codes
X.25 Logging Location Codes
X.25 logging falls under the transport subsystem (SUB0006). It logs 4
different classes of errors. They are:
Class 2 — Internal Errors. This usually means a bug somewhere.
Class 3 — Resource Errors. These should be recoverable, but a
configuration adjustment may be a good idea.
Class 4 — Nodal information. This is just information about Phobos
being started and stopped. Links going up and down etc.
Class 5 — Informative. Usually just a commentary on good things
happening. If problems are occurring it is good to examine these to help.
In several of the CLAS0005 informative messages, the PARM contains
the Device ID, VC number, cause, and diagnostic. The Device ID is in
the first 4 bits. This number differentiates between different cards
when multiple cards per network ar used. If only one card is configured
for the network, the Device ID is 0. The VC number is in the next 12
bits, the cause is in the third byte, and the diagnostic is in the fourth
byte.
1–70 CLAS0002 MESSAGE: None
CAUSE: X.25 tried to send a message, but the send_msg call failed
(PARM = status from send_msg).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
100 CLAS0002 MESSAGE: None
CAUSE: A packet smaller than the minimum packet length (4 bytes)
was received from the DTC (PARM = length of packet).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
101 CLAS0002 MESSAGE: None
CAUSE: An unrecognized packet was received from the DTC (PARM =
ALCP packet type).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
102 CLAS0002 MESSAGE: None
CAUSE: Internal Error. Map_X25_Update failed (PARM = status from
Map_X25_Update).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
103 CLAS0002 MESSAGE: None
CAUSE: Internal Error. Map_X25_Update failed (PARM = status from
Map_X25_Update).