NS3000/iX Error Messages Reference Manual (36923-90043)

712 Chapter22
Logging Location Codes Continued
X.25 Logging Location Codes
210 CLAS0002 MESSAGE: None
CAUSE: Reading the configuration buffer failed on a Netcontrol
Update (PARM = status and length).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
211 CLAS0002 MESSAGE: None
CAUSE: There are more facility sets in the configuration file than
allowed (PARM = number of facility sets).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
212 CLAS0002 MESSAGE: None
CAUSE: An error occurred while reading a facility set from the
configuration file (PARM = length).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
213 CLAS0002 MESSAGE: Internal Error.
CAUSE: An escape occurred inside X.25 (PARM = escape code).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
214 CLAS0005 MESSAGE: None
CAUSE: An N-Disconnect packet was sent because a message arrived
that was greater than 30 kilobytes (PARM = Device ID, VC number,
cause, diagnostic).
ACTION: Change the remote application to send less than 30 kilobytes
of data at a time.
215 CLAS0002 MESSAGE: Internal Error.
CAUSE: Netfc_create_pool failed right after a Netfc_delete_pool
(PARM = status from Netfc_create_pool).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
216 CLAS0002 MESSAGE: Internal Error.
CAUSE: Netfc_delete_pool failed on expedited semaphore pool
(PARM = status from Netfc_delete_pool).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
217 CLAS0002 MESSAGE: Internal Error.
CAUSE: Netfc_delete_pool failed on regular semaphore pool
(PARM = status from Netfc_delete_pool).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
218 CLAS0005 MESSAGE: None
CAUSE: An incoming connection request was rejected because it