NS3000/iX Error Messages Reference Manual (36923-90043)

714 Chapter22
Logging Location Codes Continued
X.25 Logging Location Codes
connection request was received by the system. (PARM = Status from
Map_find_best_device).
ACTION: Verify that the link between the system and the DTC is up:
From the system, check for a non-zero LDEV in the NETCONTROL
STATUS;NI=x25niname> display. From OpenView DTC Manager,
check the host entries at the end of the X.25 level 3 status display. If the
link is up, try the connection again. If this message is logged
consistently, see Appendix A , “Submitting a CR,” of this manual.
225 CLAS0002 MESSAGE: None
CAUSE: X.25 tried to send a message to X25STAT but the call failed.
(PARM = status from send_msg).
ACTION: Try running X25STAT again. If this logging message is logged
consistently, see Appendix A , “Submitting a CR,” of this manual.
226 CLAS0004 MESSAGE: None
CAUSE: Link brought down with open connections. This is a result of a
Netcontrol Stop on this X.25 network. (PARM = Connections in use on
this link).
ACTION: None. This is an informative message.
228 CLAS0002 MESSAGE: Internal Error.
CAUSE: Link_ptr is nil. (PARM = link ID).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
229 CLAS0002 MESSAGE: Internal Error.
CAUSE: BMGR_DELETE_POOL call failed while start sequence was
aborting. (PARM = status from call).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
230 CLAS0002 MESSAGE: Internal Error.
CAUSE: Unknown link for disconnect reply. (PARM = link ID).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
231 CLAS0002 MESSAGE: Internal Error.
CAUSE: Unknown link while DELLINKing. (PARM = link ID).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
232 CLAS0002 MESSAGE: Internal Error.
CAUSE: Unknown link. (PARM = link ID).
ACTION: See Appendix A , “Submitting a CR,” of this manual.