NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 6 85
Virtual Terminal (VT ERROR) Error Messages
51 MESSAGE: VT TERMINATED, COULD NOT FOPEN TERMINAL.
CAUSE: A File System error has occurred; the terminal was not
accessible by the VT program.
ACTION: Save the Node Management logfile, and if the problem recurs,
see Appendix A , “Submitting a CR,” of this manual.
52 MESSAGE: VT TERMINATED, INVALID DEVICE FOR SESSION.
CAUSE: Your session device is not an acceptable MPE session device.
ACTION: Verify the configuration in SYSGEN.
53 MESSAGE: NO DEVICE STRING SPECIFIED FOR REVERSE-VT.
CAUSE: The device string was omitted in the FOPEN or file equation.
ACTION: Insert a device string.
54 MESSAGE: INVALID TERMINALL SPEED FOR REVERSE-VT.
CAUSE: The terminal did not respond since the speed in the
configuration file and the hardware-configured speed do not match.
ACTION: Set the hardware to the speed in the configuration file.
55 MESSAGE: LOCAL NS GOING DOWN, CONNECTION FAILED.
CAUSE: The connection to the remote machine failed because the local
network services are going down.
ACTION: See Appendix A , “Submitting a CR,” to this manual.
57 MESSAGE: ATTEMPT TO SET OR STEAL BREAK FAILED.
CAUSE: An error occurred while VT trying to set or steal break for the
remote session.
ACTION: Bring up the network services on the local node, and
re-establish the connection.
58 MESSAGE: SET QUIESE IOQ FAILED.
CAUSE: The ATTACHIO failed with an abnormal completion code.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
59 MESSAGE: SET $BACK ENVIRONMENT INFO FAILED.
CAUSE: Could not set the $BACK information to environment table.
ACTION: Close the DSLINE, re-open the line, and then initiate a new
remote session.