NS3000/iX NMMGR Screens Reference Manual - Edition 8 (36922-90038)
Chapter 1 17
Overview
Using The Path Name
Using The Path Name
The path name is used to go directly to a given screen. A path name
may include one or more of the following variables:
• NIname is the name of the network interface you want to modify.
• linkname is the name of the link you want to modify.
• gatewayn is the name of the gateway you want to modify.
• mapentry is the name of the entry you want to modify in the router
mapping table.
• fsetname is the name of the X.25 facility set you want to modify.
The path name is specified with each screen in this manual. To use a
path name to go directly to a screen, type the path name preceded by an
“@” in the command window and press the
[Enter] key. For example, to go
directly to the screen that contains the parameters for the X.25 facility
set called “MySet” for the NI called “MyX25NI,” you would type the
following: @NETXPORT.NI.MyX25NI.PROTOCOL.X25.FACSET.MySet