NS3000/iX NMMGR Screens Reference Manual - Edition 8 (36922-90038)

Chapter 11 239

100Base-T Network Interface Conﬁguration Screens

Probe Protocol Conﬁguration

The Probe Protocol Conﬁguration screen (#92) in Figure 11-6 is

displayed when you press the

[Go To PROBE] function at the Protocol

Conﬁguration screen (Figure 11-4). It is also displayed when you type

the path name:

@NETXPORT.NI.

NIname

.PROTOCOL.PROBE

in the command window of any screen and press the

[Enter] key, where

NIname is a conﬁgured BT100 NI.

Figure 11-6 Probe Protocol Conﬁguration Screen

This screen allows you to conﬁgure the information required for the

probe protocol. The probe protocol exists on a 100Base-T network using

the IEEE 802.3 protocol to provide a means of exchanging addressing

and naming information between nodes. Press the

[Save Data] function

key to transfer the data displayed on the screen to the conﬁguration ﬁle

you are creating or updating. Verify that the data record has been

created by checking that the Data ﬂag is set to Y.