NS3000/iX NMMGR Screens Reference Manual - Edition 9 (36922-90040)

234 Chapter10
Gateway Half Network Interface Configuration Screens
Gateway Half Dial Link Configuration
Fields Enable dial ID protocol (Y/N)
A Y (Yes) value activates the dial ID protocol for a dial
link. The dial ID protocol verifies the identity of a
remote node and ensures that both local and remote
nodes have the required security access.
The dial ID protocol should be disabled (by entering N)
only to connect a dial link to a remote node that does
not support the dial ID protocol (that is, a non-HP
node).
Related screens:
• NETXPORT.NI.NIname.LINK
Configures a link name and type.
• NETXPORT.NI.NIname.PROTOCOL.DIAL.SECURITY
Configures security strings for this node.
Default value: Y
Range: Y or N
Phone number
This is the telephone number of this node’s partner
gateway half. Enter the telephone number as a
combination of decimal numbers (0 through 9), dashes,
and the following special characters:
/ Separator used for automatic call units
that have second dial-tone detect.
E Optional end-of-number indicator.
D One second delay (used for European
modems and automatic call units that
require built-in delays).
# Defined by local phone system.
* Defined by local phone system.
Enter ! to disable outbound dialing. A ! is required if
the destination node is a personal computer.
Default value: None