User's Manual

HP PS110 Wireless VPN Router Quickstart 2
Radio and antennas
The PS110 provides a single dual-band radio with three antennas supporting
3x3 MIMO three-spatial-stream 802.11n. The PS110 supports 802.11b/g/n
operation modes at 2.4 GHz or 802.11a/n operation modes at 5 GHz. The PS110
does not support concurrent operation at 2.4 GHz and 5 GHz.
Wi-Fi On/Off button
Press the button for more than three seconds and then release it to turn the
wireless function of the router on or off.
WPS button
Press the button for more than three seconds to enable Wi-Fi Protected Setup
(WPS) and allow a wireless client device to securely join the network. Within
two minutes, initiate the WPS procedure on the wireless client device. See the
wireless client documentation for information on how to connect to access
points using WPS.
Reset button
The Reset button is accessible through a hole on the rear panel of the PS110,
labeled as 6 on page 1. To reset the PS110 to factory defaults, insert a paper clip
into the Reset button hole and hold the button for more than three seconds,
then release.
Status LEDs
LED State Description
Power
Off The PS110 has no power.
Green The PS110 is fully operational.
Alert
Amber
The PS110 has a hardware failure or the software
has failed to load. Reset or power cycle the
PS110. If this condition persists, contact HP
customer support.
Flashing
amber
Indicates one of the following conditions:
• The PS110 is starting up following a hard or
soft reset.
• The PS110 is upgrading firmware.
• The PS110 software is being reset to factory
defaults.
• A hacker attack is detected. The Alert LED
remains flashing until the hacker attack
ends.
• The Alert LED remains flashing for 30
seconds when a USB overcurrent condition
is detected.
USB
Off
Either an unsupported or defective USB device is
attached.
Green A USB device is attached.
WPS
Off WPS is not active.
Green On for 20 seconds when WPS is successful.
Flashing
green
WPS is active and waiting for a wireless client
device to join the network.
WAN
Off The WAN port is not connected.
Green
The WAN port has a valid link. Flashing indicates
network activity.
LAN 1
–4
Off The LAN port is not connected.
Green
The LAN port has a valid link. Flashing indicates
network activity.
2.4 GHz
Off The 2.4 GHz radio is disabled.
Green
The 2.4 GHz radio is enabled. Flashing indicates
wireless network activity.
5 GHz
Off The 5 GHz radio is disabled.
Green
The 5 GHz radio is enabled. Flashing indicates
wireless network activity.
LED State Description