MSL5000 and 6000 Series Tape Libraries User Guide

Optional Fibre Channel Card
207HP StorageWorks MSL5000 and MSL6000 Series Tape Libraries User Guide
Configuration
For detailed configuration information, refer to the HP StorageWorks Network
Storage Router User Guide available on the MSL Series tape library
documentation CD, or on the HP website at:
http://www.hp.com/support .
Before attempting to configure the Fibre Channel board, a basic understanding of
Fibre Channel and SCSI devices is recommended. For information on SCSI
standards, refer to publications from X3T10 committee of ANSI (American
National Standards Institute). For more information on Fibre Channel standards,
refer to publications from the X3T11 committee of ANSI. To purchase approved
American National Standards and Technical Reports, contact ANSI at
[phone].
Default Ethernet Settings
The basic factory default values are:
■ IP address: http://1.1.1.1/
■ Subnet mask: 255.255.255.0
■ Gateway address: 0.0.0.0
■ User name: root
■ Password: password
HP recommends that you change these values from the defaults.
All settings within the configuration are pre-set with default values. These values
are set to allow the Fibre Channel card into most HP environments with little or no
configuration changes.
After changing the basic default values listed above, carefully consider any
additional configuration changes.
After the initial configuration is established, HP recommends backing up the
configuration to an external file via the FTP file transfer protocol option. If
needed, during a recovery process, this file can be restored back onto the router.