MSL5000 and 6000 Series Tape Libraries User Guide

Installation
45HP StorageWorks MSL5000 and MSL6000 Series Tape Libraries User Guide
WARNING: A rack enclosure might become unstable if more than one library
is extended for any reason. Extend only one library at a time.
7. Push in on the rail locks to release the library and slide the library completely
into the rack enclosure.
8. Fully tighten the rear rail screws.
Figure 14: Installing the library (two-drive model shown)
9. Remove the tape to open the doors for installation.
10. Remove and discard the pull-tabs used to block the latch mechanism.
Note: Do not close the doors. You must have access to the two retaining screws to
complete the installation. (If necessary, see Chapter 4, “Operation,” for information on
how to manually open the library doors.)
11. With the doors open, secure the front panel to the rack enclosure using the two
retaining screws (see Figure 15). Close the doors.
You can now cable the library.