MSL5000 and 6000 Series Tape Libraries User Guide

Installation
47HP StorageWorks MSL5000 and MSL6000 Series Tape Libraries User Guide
Applying Power to the Library
To apply power to the library (see Figure 16):
1. Connect each supplied power cord 1 to each power supply receptacle.
Note: The left-hand AC power receptacle is for the bottom power supply. The
right-hand AC receptacle is for the top power supply. (four-drive models only).
2. Toggle each power switch 2 on.
Note: You can remove the appliqué from the GUI touch screen by catching one corner
and carefully lifting it.
3. Press anywhere on the graphical user interface (GUI) touch screen 3 to
activate the display and turn the library on.
Note: The SCSI terminator must always be connected to the library controller board for
proper operation if the library is configured as a master or standalone.