MSL5000 and 6000 Series Tape Libraries User Guide

Operation
99HP StorageWorks MSL5000 and MSL6000 Series Tape Libraries User Guide
Inserting and Removing Tape Cartridges
Unless you are using the mail slot(s), a tape magazine must be removed from the
library to remove or insert tape cartridges. Make sure the slot you want to use is
not already reserved for a tape cartridge that is now in a tape drive. The safest way
to do this is to unload all tape drives before removing a magazine. You can unload
all the tape drives either through your host system software or by using the
LOAD/UNLOAD command from the Library Option menu.
Note: Do not add more tape cartridges to the library than its rated slot capacity.
Caution: Ultrium and SDLT/DLT tape drives require special cleaning cartridges
and data cartridges formatted specifically for the drive technology. To avoid
damage to your tape drive, it is critical to use appropriate cleaning cartridges
and properly formatted data cartridges. Contact an HP authorized dealer or
sales representative for current compatibility and availability.
Removing Magazines
Library magazine removal is a manual operation. Access the magazines using the
Magazine Access option from the library Status screen. This option lets you open
the left- or right-hand magazine doors separately, or all magazine doors at the
same time. After opening the appropriate magazine door, pull the magazine out
from the library chassis (see Figure 58).