Owner's manual
Table Of Contents
- Contents
- Introduction
- Installation
- Library Configuration
- Changing Default Configuration Settings
- Setting a SCSI ID
- Setting Up a Reserved Slot
- Reserved Slot Numbering
- Figure 24 Reserved slot locations, SDLT
- Figure 25 Reserved slot locations, Ultrium (MSL6030)
- Figure 26 Reserved slot locations, lower module, SDLT
- Figure 27 Reserved slot locations, lower module, Ultrium (MSL6060)
- Figure 28 Total reserved slots screen
- Figure 29 Reserved slots numeric keypad screen
- Figure 30 Total reserved slots confirmation screen
- Reserved Slot Numbering
- Configuring the Network Settings
- Operation
- Front Panel
- Library Display Screens and Options
- Menu Selections
- Inserting and Removing Tape Cartridges
- Remote Management Interface
- Maintenance
- Troubleshooting
- Regulatory compliance notices
- Regulatory compliance identification numbers
- Federal Communications Commission notice
- Canadian notice (Avis Canadien)
- European Union notice
- Japanese notices
- Korean notices
- Taiwanese notices
- Laser compliance notices
- Recycling notices
- Disposal of waste equipment by users in private household in the European Union
- Danish notice
- Dutch notice
- Czecholslovakian notice
- Estonian notice
- Finnish notice
- French notice
- German notice
- Greek notice
- Hungarian notice
- Italian notice
- Latvian notice
- Lithuanian notice
- Polish notice
- Portuguese notice
- Slovakian notice
- Slovenian notice
- Spanish notice
- Swedish notice
- Specifications
- Electrostatic Discharge
- Configuration Examples
- Optional Fibre Channel Card
- Index
Troubleshooting106
200A Menu Mode • Take the library out of the Menu Mode
via the backspace using the LCD touch
display.
• Update the Map using the LCD touch
display. (Menu -> Maintenance -> Force
reconfiguration)
200C Cart Inaccessible
(For an SDLT drive, indicates the tape is
not in the unloaded state. For an Ultrium
drive, indicates the tape is not ejected.
Cartridge in drive is not accessible from
changer.)
• Invalid user initiated operation. Select
parameters correctly and try again.
• Ensure drive is powered on.
• Ensure the drive shows good status
through the drive status window.
• Check the tape cartridge used in the last
operation for damage.
• Reactivate drive using control panel
maintenance menu and reseat drive.
200D Drive In Error
(A general drive error detected by control
task)
• Cycle power to the library or reboot
using the GUI touch screen.
• Ensure the drive shows good status
through the drive status window.
• Reseat drive.
200E No Magazine
(Cannot move from changer. Element not
installed.)
• Press the Enter button to clear the
message.
• Invalid user initiated operation. Select
parameters correctly and try again.
• Check for magazine.
• Replace magazine.
200F Removal Prevented
(Receive medium prevent removal from
drive for a fetch.)
• Attempt to unload drive from software. If
fails, power off unit, disconnect from SCSI
bus, and retry operation.
• Invalid host initiated operation. Check
that application is certified to work with
your library and has up-to-date patches.
• Invalid user initiated operation. Select
parameters correctly and try again.
• Check for firmware tape in drive.
• Check for cleaning tape in drive.
• Press the Enter button to clear the
message.
Table 10 Fault Symptom Codes (continued)
FSC Message ERP