Owner's manual
Table Of Contents
- Contents
- Introduction
- Installation
- Library Configuration
- Changing Default Configuration Settings
- Setting a SCSI ID
- Setting Up a Reserved Slot
- Reserved Slot Numbering
- Figure 24 Reserved slot locations, SDLT
- Figure 25 Reserved slot locations, Ultrium (MSL6030)
- Figure 26 Reserved slot locations, lower module, SDLT
- Figure 27 Reserved slot locations, lower module, Ultrium (MSL6060)
- Figure 28 Total reserved slots screen
- Figure 29 Reserved slots numeric keypad screen
- Figure 30 Total reserved slots confirmation screen
- Reserved Slot Numbering
- Configuring the Network Settings
- Operation
- Front Panel
- Library Display Screens and Options
- Menu Selections
- Inserting and Removing Tape Cartridges
- Remote Management Interface
- Maintenance
- Troubleshooting
- Regulatory compliance notices
- Regulatory compliance identification numbers
- Federal Communications Commission notice
- Canadian notice (Avis Canadien)
- European Union notice
- Japanese notices
- Korean notices
- Taiwanese notices
- Laser compliance notices
- Recycling notices
- Disposal of waste equipment by users in private household in the European Union
- Danish notice
- Dutch notice
- Czecholslovakian notice
- Estonian notice
- Finnish notice
- French notice
- German notice
- Greek notice
- Hungarian notice
- Italian notice
- Latvian notice
- Lithuanian notice
- Polish notice
- Portuguese notice
- Slovakian notice
- Slovenian notice
- Spanish notice
- Swedish notice
- Specifications
- Electrostatic Discharge
- Configuration Examples
- Optional Fibre Channel Card
- Index
MSL6000 series tape library user guide 91
6 Maintenance
This chapter includes procedures for:
• Using the Library Maintenance Menu, page 91
• Maintaining Tape Cartridges, page 92
• Running a Cleaning Cartridge, page 93
• Replacing a Cleaning Cartridge in a Reserved Slot, page 96
• Updating Firmware, page 97
Using the Library Maintenance Menu
You can use the library Maintenance menu to perform system maintenance. Access this menu from
the GUI touch screen by selecting Menu > Utilities > Maintenance. Table 9 lists the available
options.
Table 9 Maintenance Menu
Option Description
Clean Drive Cleans a drive by selecting the drive to
be cleaned, and the slot or mailslot
where the cleaning cartridge is
located.
Replace Drive Deactivates a drive prior to its removal.
Drive Format Formats a tape once the density and
compression settings have been
selected.
Park Drives Parks all drives prior to transporting the
library.
Set User Defaults Restores the library to its firmware
default settings.
Force Reconfiguration Forces library to reconfigure based on
current or new SCSI elements.