- Hewlett-Packard Reference CD Transport Operating Manual N31.5

While repeat disc is active, the LED above the button is lit.

To return to normal play, press repeat disc again.

7REPEAT A-B

This function allows you to repeat (continuously) a particular phrase or

passage on a CD.

While a CD is playing, press repeat A-B at the beginning of the passage you

would like to repeat. At the end of the passage, press repeat A-B again. The

passage you selected will repeat continuously. While repeat A-B is active, A

then B will alternate appearing in the space preceding the track number on

the display.

To return to normal play, press repeat A-B again. Alternatively, you may

press stop to leave the repeat A-B mode and enter stop. Directly accessing

a point after the “B” point of your A-B loop (via pressing next track, direct

time

access, or direct track access) will cancel the repeat A-B loop and re-

turn you to normal play mode at your selected point.

8REPEAT TRACK

To repeat (continuously) the track in play, press this button. Note that this

function and the repeat disc function are mutually exclusive.

While repeat track is active, the LED above the button is lighted.

To return to normal play, press repeat track again.

9PREVIEW

This function allows you to play only the introduction of each track on a

CD or in a program.

Once a CD is loaded and ready for play, press preview. Beginning with the

first track on the CD (or the first track in the program), the Nº31.5 will play

the first ten seconds of the track, skip to the second track and play the first

ten seconds of that track, and so on.

While preview is active, the track part of the display flashes. (See Display.)

To return to normal play, press preview again, or press play. (See Top Panel.)

10 PROGRAM CLEAR

Pressing this button erases any temporary program, and also temporarily

overrides a previously saved program. (See Programming.) After pressing

program clear, the display will show PROG CLEARED.

Pressing program clear, followed by pressing program save (12), perma-

nently erases a program from the Nº31.5’s memory and displays

PROG DELETED in the main display.

If you press program clear when there is no program in the Nº31.5’s

memory, the display will show NO PROGRAM.