HP Pro x2 612 G1 - Maintenance and Service Guide

3. Remove the fingerprint reader board (3).
Reverse this procedure to install the fingerprint reader board.
Button board
Description Spare part number
Button board (includes cable, power button, volume control buttons, and orientation switch) 766613-001
Before removing the button board, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and
then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the back cover (see
Back cover on page 39).
Remove the button board:
1. Remove the two Philllips PM1.5×2.4 screws (1) that secure the button board to the back cover.
42 Chapter 5 Removal and replacement procedures