HP Pro x2 612 G1 - Maintenance and Service Guide

3. Remove the five Philllips PM2.4×4.6 screws (2) that secure the tablet battery to the
display panel assembly.
4. Remove the tablet battery (3).
Reverse this procedure to install the tablet battery.
Solid-state drive
Description Spare part number
256-GB, M2, SATA-3, solid-state drive 766636-001
256-GB, M2, SATA-3, SED, OPAL2, solid-state drive 766637-001
180-GB, M2, SATA-3, solid-state drive 766634-001
180-GB, M2, SATA-3, SED, OPAL1, solid-state drive 766635-001
128-GB, M2, SATA-3, solid-state drive 766633-001
64-GB, M2, SATA-3, solid-state drive 766632-001
Before removing the solid-state drive, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and
then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the back cover (see
Back cover on page 39).
5. Disconnect the tablet battery cable from the system board (see
Tablet battery on page 44).
Tablet replacement procedures 45