Manual

Specifications 11
Specifications
In this section
NC373T specifications ........................................................................................................................... 11
UTP CAT5 cable .................................................................................................................................... 11
NC373T specifications
Specification Value
Network controller chipsets BCM5708C
Bus type PCI Express
Bus width Four lanes
Data transfer method Bus master DMA
Power requirement Operating voltage: 3.3 V +/- 5%
Power consumption: 6.6 watts
Maximum: 2 A @ 3.3 V
Standards supported IEEE 802.3, 802.3u, 802.3ab, 802.3x, 802.3ad, 802.1p, 802.1Q
Dimensions 16.8 cm x 6.35 cm (without bracket) (6.6 x 2.5 inches (L x W))
Connector and distances One RJ-45 connector, cable and lengths as follows:
10BASE-T: category 3, 4, or 5 UTP 100 meters (328 feet)
100BASE-TX: category 5 UTP 100 meters (328 feet)
1000BASE-TX: category 5 UTP 100 meters (328 feet)
Interrupts supported Automatically configured
Temperature range Operating: 32° F to 131° F (0° C to 55° C)
Storage: -40° C to 85° C (-40° F to 185° F)
Relative humidity (non-condensing) Operating: 10% to 90%
Storage: 5% to 95%
Safety compliance CSA mark (US and Canada)
CE mark
EN 60590
UTP CAT5 cable
The NC373T adapter can use existing UTP CAT5 (or better) cable to deliver Gigabit Ethernet over
copper, according to the IEEE 802.3ab specifications. For new installations, CAT5e (enhanced CAT5)
cable is recommended. For troubleshooting and other information about cabling, see UTP Cable
Specifications.