User's Manual

6-37
Setup Menus
Line Block Mode
Factory default: Unselected
The setting of this option determines how much data is transmitted when the emulation
is in Block mode and the Enter key is pressed.
When unselected, the contents of the screen (page) will be sent to the host. When
selected, the contents of the current cursor line will be sent.
Multinational Character Sets
Factory default: Selected
The setting of this option determines which characters may be generated from the
keyboard.
When unselected, the character set for the keyboard nationality specified in the
Emulation Settings dialog box is mapped to G0, the default character set mode (as
indicated on the status line). In effect, national characters from the Additional character
set are swapped with Standard (ASCII) characters to form the National set mapped to
G0, so the Additional set contains the missing ASCII characters. This means that you
can still generate the full range of ASCII and Additional characters by using the Char
Set function (refer to the PT250 Emulation chapter for details).
When this option is selected, both ASCII and Additional characters are available,
enabling characters from any keyboard nationality to be generated.
Truncate At End Of Line
Factory default: Selected
This option determines what happens to received characters when the rightmost
column of the display is reached.
When unselected, on reaching the end of the line, the next character will be placed in
the first column of the following line. When this option is selected, following
characters will not be displayed.
Screen Wrap
Factory default: Unselected
When screen wrap is selected, display memory is treated in a circular fashion. When
the cursor reaches the last line it will automatically wrap to the first line again, and vice
versa.
When screen wrap is unselected, the cursor will not move above the first line or below
the last line.