User's Manual

15-2
PT250 Emulation
Make the relevant selections then click OK to return to the Host Information
dialog box, then click Next to display the Advanced Options dialog box.
6. Click Finish to return to the Terminal Connection Manager.
7. In the Terminal Connection Manager, display the Connections list, select the
session name you specified earlier in step 3, then click the Connect button.
The PT250 emulation is configured using the PT250 Settings dialog box which is
described in the Setup Menus chapter.
Non-WBT Mode
This section describes the basic procedure for creating a session configuration when
the terminal is not in WBT mode. The options available are described in detail in the
Setup Menus chapter.
1. Display the Settings menu from the command bar and select Emulation... to
display the Emulation Settings dialog box.
2. Select the PT250 terminal emulation in the Alpha Emulation list box.
3. Display the File menu from the command bar and select New Connection to
display the New Connection dialog box.
4. Select the type of host connection required in the Type list box.
For a TCP/IP connection, select TCP/IP, enter the name or internet address of the
host computer in the Connect To box, then click Configure for additional Telnet
options. Refer to the TCP/IP Connection Settings section in chapter 2 for details.
For a modem connection, select Modem, specify the communications port in the
Connect To box, then click Configure to display configuration options. Refer to
the Modem Connection Settings section in chapter 2 for details.
For a serial connection, select Serial, specify the communications port in the
Connect To box, then click Configure for additional serial options. Refer to the
Serial Connection Settings section in chapter 2 for details.
5. When you have specified the required settings in the New Connection dialog box,
click the Connect button to make the connection.
Note: You can save these settings as a connection template using
the Save Session As dialog box. Refer to the Setup Menus
chapter for details.
The PT250 emulation is configured using the PT250 Settings dialog box which is
described in the Setup Menus chapter.