User's Manual

C-61
Host Command Summary
Siemens 97801 Emulation
CHARACTER SET SELECTION
Assign International character set to G0 ESC ( @
Assign International character set to G1 ESC ) @
Assign International A character set to G0 ESC ( B
Assign International A character set to G1 ESC ) B
Assign German character set to G0 ESC ( K
Assign German character set to G1 ESC ) K
Assign Brackets character set to G0 ESC ( w
Assign Brackets character set to G1 ESC ) w
Assign FACET character set to G0 ESC ( c
Assign FACET character set to G1 ESC ) c
Assign IBM character set to G0 ESC ( v
Assign IBM character set to G1 ESC ) v
Assign Euro character set to G0 ESC ( u
Assign Euro character set to G1 ESC ) u
Assign Mathematics Symbols character set to G0 ESC ( t
Assign Mathematics Symbols character set to G1 ESC ) t
Assign Blanks character set to G0 ESC ( y
Assign Blanks character set to G1 ESC ) y
Assign G2 to G0 ESC ( x
Assign G2 to G1 ESC ) x
Load G2 with character set (*s = @ or B, K, w ...) ESC * *s
Load character generator address(es) with new symbol ESC R B ... ESC \
(Three bytes address and 28 byte description of pattern in hex format)
Switch to G0 (same as keyboard Ctrl + O) SI
Switch to G1 (same as keyboard Ctrl + N) SO
Switch within G0 (national/international) ESC [ 5 v
Lock Change Code key ESC [ 10 v
Unlock Change Code key ESC [ 11 v
Report current code set ESC [ 13 v
CURSOR
Cursor on ESC [ 7 p
Cursor off ESC [ 6 p
Move cursor up * lines ESC [ * A
Move cursor down * lines ESC [ * B
Move cursor right * columns ESC [ * C
Move cursor left * columns ESC [ * D
Move cursor to line *l and column *c ESC [ *l ; *c H
Report cursor position ESC [ 6 n
Short poll of cursor position ESC [ 5 p
Move cursor left one column BS
Move cursor one tab to the right HT
Move cursor * tabs to the left ESC [ * Z
Line Feed LF
Carriage Return CR
Move cursor to begining of next line ESC E