User's Manual

6-43
Setup Menus
Wyse Settings
This dialog box is displayed by selecting Wyse in the Settings menu. Note that some
of the settings apply to the TVI 910+, TVI 920, TVI 925, ADDS A2 and HZ 1500
emulations in addition to the Wyse emulations. Also, some settings may not apply to
the particular Wyse emulation currently running. Selecting a setting that is not
applicable to the current emulation will cause the emulator to use the default setting for
that emulation when the dialog box is exited.
Note: The Tab Stops dialog box displayed by clicking the Set Tabs
button is described later in this chapter, after the Terminal
Settings description.
Lines
Factory default: 24
This option applies to the WY-50+ and WY-60 emulations and specifies the number
of data lines displayed on the screen below the status line. Note that the other
emulations only support 24 lines and a label line.
24 24 data lines and a label line at the bottom.
25 25 data lines but no label line.
42 42 data lines and a label line at the bottom.
43 43 data lines but no label line.