User's Manual

C-1

Host Command Summary

This appendix lists the host commands that are valid in each terminal

emulation mode. Additional special commands are listed at the back.

The following conventions are used in this command list. Spaces in a command are for

clarity only and are not to be entered as part of the command. A space character that is

part of the command will be shown as SP. An asterisk (*) in a command indicates the

location of one or more parameters except otherwise indicated next to the command.

Note that IBM 3270 and IBM 5250 emulation commands are not included because of

their complexity. Refer to the manuals supplied with these terminals for the host

commands that are supported.

VT52 Emulation

CHARACTER SET SELECTION

Invoke G0 character set SI

Invoke G1 character set SO

Select G0 character set ESC G

Select Line Drawing character set ESC F

CURSOR

Direct cursor addressing (1 to 96 = SP to DEL) ESC Y *line *column

Insert FF character & advance cursor FF

Line feed LF

Move cursor down one line ESC B

Move cursor down one line VT

Move cursor home ESC H

Move cursor one column left BS

Move cursor one column left ESC D

Move cursor one column right ESC C

Move cursor to left margin of current line CR

Move cursor to next tab stop HT

Move cursor up one line ESC A

Reverse line feed ESC I