Owner's manual

1 Installation Overview

This chapter contains simplified setup information about your HP NetServer

E 45. For complete setup instructions, consult the HP NetServer E 45 Installation

Road Map.

Verify Contents

Unpack and verify the contents of the shipping box against the Contents

Checklist included with your NetServer. If anything is missing or damaged,

contact your reseller.

View the README File

1. Press the power-on button. Open the NetServer front door and press the

CD-ROM drive eject button. Place the HP NetServer Navigator CD-ROM

in the drive and press the eject button again to close the drive. Turn the

power off, wait 10 seconds and turn the power on again. If the system fails

to boot, follow the diagnostic instructions on the screen.

2. Go to the Navigator Main Menu. If the language needs to be changed,

select "Set Preferences."

3. Select "README File." The README file contains the latest

information to help you install your HP NetServer. Read it carefully before

beginning your installation.

You can now boot the Navigator CD-ROM and run Diagnostic Assistant

if you want to verify system operation as shipped.

4. If you are installing additional hardware, such as memory, accessory

boards, or mass storage devices, you will need to remove the cover. Go to

"Remove the Cover."

If you are not installing additional hardware, go to "Configure the HP

NetServer."