User guide

Chapter 7 Rack Mounting the HP Netserver (2-Post)
60
NOTE If you want to mount your Netserver in a third-party rack not
mentioned in this guide, you may find relevant documentation
on HP’s web site at the following URL:
http://www.hp.com/netserver/support
Before mounting the Netserver, determine the Netserver’s location in the rack
relative to other rack components. The HP Netserver LP 1000r rack mounting kit
only requires one EIA unit of space in the rack. Proper placement is vital both for
safety and operating efficiency. For more information, refer to "Rack
Configuration Tools" later in this chapter.
NOTE If the HP Netserver is completely configured by the vendor
before delivery to the customer, then mounting the HP
Netserver in the rack may be the final step in the installation
procedure. If the vendor configures the HP Netserver at the
customer’s site, installation of the network operating system
and other software may occur after the HP Netserver is
mounted in the rack.
WARNING The HP Netserver weighs 32 lbs. (14.5 kg.) fully loaded. To
prevent an accident, use two people when placing the
Netserver into the rack.
CAUTION If other rack components are to be mounted in the rack below
the HP Netserver, install those components before starting to
mount the Netserver.
Tools Required
To assemble the rack mount kit and install the HP Netserver on it, you need these
tools.
• T-15 Torx Driver (Bracket mounting)
• Number 2 Phillips screwdriver (Rack mounting)
• Masking tape or marking pen