HP Workstations - Dual-port NIC installation

Step 2—Installing the dual-port NIC
Introduction
This section describes how to install the NIC in your workstation.
Procedure: Installing the NIC
Table 2 Installing the NIC
Step Action
1 Release the PCI retainer levers by pressing them down, then out (1), as shown next.
2 Remove the applicable PCI Express slot cover (2).
3 Verify that the keyed components of the card align with the socket.
Install the dual-port NIC by pressing it securely into the slot (3).
4 When the card is installed, close the PCI levers (4).
4 Dual-port NIC installation ENWW