HP xw6600 and HP xw8600 Workstations - Small form factor bay converter and hard drive installation
Table Of Contents
- Small form factor bay converter and hard drive installation
- HP xw6600 and HP xw8600 Workstations
- Kit contents
- Warnings and cautions
- System requirements
- Tools required
- Step 1–Preparing the workstation
- Step 2–Configuring the SFF hard drive carrier for SFF hard drives number 1, 2, and 3
- Step 3–Configuring a second SFF hard drive carrier for the HP xw8600 Workstation
- Step 4–Reassembling the workstation
6. On the SFF hard drive carrier, attach one of the removed hard drive mounting rails to the carrier,
oriented as shown in the following two figures. To affix the mounting rail, engage the four mounting
rail pins with the matching holes in the carrier.
Figure 6 Installing a mounting rail on the carrier (SFF hard drive number 1 shown loaded)
NOTE: When correctly installed, the mounting rail locking/release tabs are located adjacent to
the loaded SFF hard drive number 1 SAS connector (see the following figure).
Figure 7 Mounting rail and carrier orientation
8 Small form factor bay converter and hard drive installation ENWW